so i have a two WS-C3750X-48T-L switches that i have
stacked, my issue is i have set up cross switch port channeling on the stack.
in my case i have ports gi1/0/1, gi1/0/2, gi2/0/1, gi2/0/2 in a single
port-group. this port group is connected to a single 6509 that i have on the
other end. all link lights look fine on the 6509 side but on the 3750 side if i
connect even one port on the 3750 the link light starts blinking green very
fast. every thing iv learns stays that is either a loop or a duplex miss match.
note there are no computers besides an APC transfer switch plugged in to the
3750 stack on sw2. is this link light a product of the stacking and is it
normal. if it isn't which im thinking its not... how would i troubleshoot
something that has a loop in it by design. connectivity to the APC works great
but there is not much traffic on the switch yet. i have span the port-channel
and don't see any STP traffic in wireshark. only a bit of broadcasts and
multicast from servers around the network.
if there is any command or additional info that is needed to help TS
this issue let me know ill get it.
xxx-3750-Rack_B#sh switch
Switch/Stack Mac Address : 000f.f75c.e300
H/W Current
Switch#
Role Mac Address Priority Version State
----------------------------------------------------------
*1
Master 000f.f75c.e300 1 0
Ready
2 Member 000f.f75d.0e80 1
0 Ready
xxx-3750-Rack_B#sh int gi2/0/1
GigabitEthernet2/0/1 is up, line protocol is up
(connected)
Hardware is Gigabit Ethernet, address is 000f.f75d.0e81 (bia
000f.f75d.0e81)
Description: portchannel to 6509-Swi#2
MTU
1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 1000Mb/s, link type is auto, media type is 1000BaseSX SFP
input
flow-control is off, output flow-control is unsupported
ARP
type: ARPA, ARP Timeout 04:00:00
Last
input 00:00:43, output 00:00:38, output hang never
Last
clearing of "show interface" counters never
Input
queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output
queue: 0/40 (size/max)
5
minute input rate 151000 bits/sec, 123 packets/sec
5
minute output rate 1000 bits/sec, 1 packets/sec
7317390 packets input, 1127298799 bytes, 0 no buffer
Received 5103412 broadcasts (3787915 multicasts)
0
runts, 0 giants, 0 throttles
0
input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0
watchdog, 3787915 multicast, 0 pause input
0
input packets with dribble condition detected
6863
packets output, 1536552 bytes, 0 underruns
0
output errors, 0 collisions, 2 interface resets
0
babbles, 0 late collision, 0 deferred
0
lost carrier, 0 no carrier, 0 PAUSE output
0
output buffer failures, 0 output buffers swapped out
xxxx-IOS-6509-Swi1#sh int gi3/7
GigabitEthernet3/7 is up, line protocol is up
(connected)
Hardware is C6k 1000Mb 802.3, address is 0009.11e6.cafe (bia
0009.11e6.cafe)
MTU
1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, media type is SX
input
flow-control is off, output flow-control is off
Clock
mode is auto
ARP
type: ARPA, ARP Timeout 04:00:00
Last
input 00:00:08, output 00:00:13, output hang never
Last
clearing of "show interface" counters 2y25w
Input
queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output
queue: 0/40 (size/max)
5
minute input rate 0 bits/sec, 0 packets/sec
5
minute output rate 135000 bits/sec, 133 packets/sec
6904
packets input, 1545692 bytes, 0 no buffer
Received 3478 broadcasts (3354 multicasts)
0
runts, 0 giants, 0 throttles
0
input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0
watchdog, 0 multicast, 0 pause input
0
input packets with dribble condition detected
7330192 packets output, 1128728395 bytes, 0 underruns
0
output errors, 0 collisions, 1 interface resets
0
babbles, 0 late collision, 0 deferred
0
lost carrier, 0 no carrier, 0 PAUSE output
0
output buffer failures, 0 output buffers swapped out
these are the only interfaces int the port
channel that are connected. note even if i connect all memebers of the port
channel i still get very fast blinking link lights.
Found the answer.... Wow I'm dumb ... WS-C3750X-48T-S gig
ports blink fast to show they are running at gig speeds maybe I will read the
documentation next time...
没有评论:
发表评论