Data plan for the GPON Internet access service

MA5600T/Huawei MA5683T /Huawei MA5680T

Configure the data according to the user requirements.Access rate

Access port

Configure the data according to the network planning.

VLAN planning

The cooperation with the upper-layer device should be considered in the VLAN planning. The upstream VLAN must be the same as that of the upper-layer device.

QoS policy

Configure the data according to the QoS policy of the entire network. Generally, the priority of the Internet access service is lower than the priorities of the voice and video services.

T-CONT ID

It is recommended that you do not use T-CONT 0 to transmit services.

GEM port index

-

ONT

Capability set profile

The ONT capability set profile must be the same as the actual capacity set.

ONT index

GPON supports a split ratio of up to 1:128. You need to plan the ONTs connected to the MA5600T/MA5603T/MA5608T to facilitate management.

Authentication mode

The password, SN, and LOID+CHECKCODE can be used for authentication.

Upper-layer LAN switch

The LAN switch transparently transmits the service packets of the MA5600T/MA5603T/MA5608T on Layer 2.

The VLAN ID must be the same as the upstream VLAN ID of the MA5600T/MA5603T/MA5608T.

-

BRAS

The BRAS performs the related configurations according to the authentication and accounting requirements for dialup users, for example, configures the access user domain (including the authentication scheme, accounting scheme, and authorization scheme bound to the domain) and specifies the RADIUS server.

If the BRAS is used to authenticate users, you need to configure the user name and the password for each user on the BRAS. If the BRAS is used to allocate IP addresses, you need to configure the corresponding IP address pool on the BRAS.